Search This Blog

Tuesday, April 1, 2014

Testing of flyback (LOPT) transformers

How and why do flyback transformers fail?
Flybacks fail in several ways:
  1. Overheating leading to cracks in the plastic and external arcing. These can often be fixed by cleaning and coating with multiple layers of high voltage sealer, corona dope, or even plastic electrical tape (as a temporary repair in a pinch).
  2. Cracked or otherwise damaged core will effect the flyback characteristics to the point where it may not work correctly or even blow the horizontal output transistor.
  3. Internal shorts in the FOCUS/SCREEN divider network, if present. One sign of this may be arcover of the FOCUS or SCREEN sparkgaps on the PCB on the neck of the CRT.
  4. Internal short circuits in the windings.
  5. Open windings.
More than one of these may apply in any given case.
First, perform a careful visual inspection with power off. Look for cracks, bulging or melted plastic, and discoloration, Look for bad solder connections at the pins of the flyback as well. If the TV or monitor can be powered safely, check for arcing or corona around the flyback and in its vicinity,
Next, perform ohmmeter tests for obvious short circuits between windings, much reduced winding resistances, and open windings.
For the low voltage windings, service manuals may provide the expected DC resistance (Sams' PhotoFact, for example). Sometimes, this will change enough to be detected - if you have an ohmmeter with a low enough scale. These are usually a fraction of an ohm. It is difficult or impossible to measure the DC resistance of the HV winding since the rectifiers are usually built in. The value is not published either.
Caution: make sure you have the TV or monitor unplugged and confirm that the main filter capacitor is discharged before touching anything! If you are going to remove or touch the CRT HV, focus, or screen wires, discharge the HV first using a well insulated high value resistor (e.g., several M ohms, 5 W) to the CRT ground strap (NOT signal ground. See the section: Safe discharging of capacitors in TVs and video monitors.
Partially short circuited windings (perhaps, just a couple of turns) and sometimes shorts in the focus/screen divider will drastically lower the Q and increase the load the flyback puts on its driving source with no outputs connected. Commercial flyback testers measure the Q by monitoring the decay time of a resonant circuit formed by a capacitor and a winding on the flyback under test after it is excited by a pulse waveform. It is possible to easily construct testers that perform a well. See the companion document Testing of Flyback (LOPT) Transformers for further information.

No comments:

Post a Comment

Best Product On Amazon Must Buy

Best Electronics Soldering Iron Kit - https://amzn.to/3gIulii

Best Desoldering Pump Soldering Iron - https://amzn.to/3egN4Qp

Best Screw Driver Set For Repairing - https://amzn.to/2OsA0ND

Best Cord less Screw Driver Set - https://amzn.to/3eqvtWw

Best & Cheap Digital Multimeter - https://amzn.to/467dOOb

Best Fold Scope Microscope Basic Kit - https://amzn.to/393WI6o

Best & Smallest 60x Microscope - https://amzn.to/477r5HQ

Microware-20x-to-1000x-8 Led-usb -   https://amzn.to/2W8DGs0

Best Magnifying-Soldering-Stand - https://amzn.to/2ZVcZrM

Supper LED TV Backlight tester - https://amzn.to/3gLyXEo

Mini Hand Drill and 20pcs Drill Bits - https://amzn.to/3fiEWAc

Popular Posts