Search This Blog

Friday, October 3, 2014

Electronic GateKeeper Circuit

 A SIMPLE PROJECT ELECTRONIC GATE KEEPER Using IC CA3140


This circuit can do the job of a Gatekeeper and intimates you if someone passes through the gate. The alarm can be an AC bell or a Lamp. The alarm turns on for 1 minute and stops if the light barrier is restored again.
Infrared rays are used as the light barrier to activate the alarm system based on a Photo transistor. The high gain NPN Darlington photo transistor L14F1 conducts when its face is illuminated with IR rays. This brings its collector to ground potential. IC1 is used as a simple voltage comparator with a potential divider R2 and R3 connected to its inverting input. So that half supply voltage (6 volts) is available to its inverting input. Its non inverting input is connected to the collector of the phototransistor. Normally the output of IC1 will be low since T1 is conducting. When the IR beam breaks, the collector of T1 becomes high and the voltage at the non inverting input of IC1 increases above the voltage at the inverting input and output becomes high. This triggers the relay driver T2 and relay turns on. Capacitor C1 gives a short delay at the non inverting input of IC1 to prevent false triggering. Capacitor C2 keeps the base of T2 high for a short time even if the IR rays restore.

Electronic Gate Keeper Schematic


Settings
1. IR rays should be aligned exactly to the Phototransistor so as to keep the alarm off.
2. Normal range of the circuit is 2 meters. This can be increased to 5 meters if a
convergent lens
is used in front of the IR LEDs.
3. A buzzer can be used in the place of the relay, if AC alarm is not required.
4. Instead of IR LEDs, a Laser pointer can be used to increase the range up to 25 meters.
5. If Laser is used, take all precautions to prevent direct viewing.
6. Enclose to the Phototransistor in a small case with an opening in front.
This prevents the entry of ambient light.
7. Fix the IR LEDs on one gate pillar and the Photo transistor on the opposite pillar with exact alignment



Electronics gatekeeper circuit idea, circuit diagram, circuit theory, project, parts list, schematic

No comments:

Post a Comment

Best Product On Amazon Must Buy

Best Electronics Soldering Iron Kit - https://amzn.to/3gIulii

Best Desoldering Pump Soldering Iron - https://amzn.to/3egN4Qp

Best Screw Driver Set For Repairing - https://amzn.to/2OsA0ND

Best Cord less Screw Driver Set - https://amzn.to/3eqvtWw

Best & Cheap Digital Multimeter - https://amzn.to/467dOOb

Best Fold Scope Microscope Basic Kit - https://amzn.to/393WI6o

Best & Smallest 60x Microscope - https://amzn.to/477r5HQ

Microware-20x-to-1000x-8 Led-usb -   https://amzn.to/2W8DGs0

Best Magnifying-Soldering-Stand - https://amzn.to/2ZVcZrM

Supper LED TV Backlight tester - https://amzn.to/3gLyXEo

Mini Hand Drill and 20pcs Drill Bits - https://amzn.to/3fiEWAc

Popular Posts