Search This Blog

Thursday, April 23, 2015

Motor burn out and under voltage protection

This is AC motor burn out protection causes of under voltage input. The principle is simple, it will check for voltage at all times. Normal voltage is 220V AC. If the voltage falls below a preset. Relay will not work and the LED is a warning. Can be set to cut no-off in the voltage during the 168-227V.
As AC main in normal level, the relay will be connect to apply AC line to motor. And AC-line fall down lower than 10% of normal voltage the relay will cut of load at once. Until the voltage is restored to its original condition. So to get back into the circuit again. Ideally, blog diagram in Figure 1.
Posted by at
Labels:

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Best Product On Amazon Must Buy

Best Electronics Soldering Iron Kit - https://amzn.to/3gIulii

Best Desoldering Pump Soldering Iron - https://amzn.to/3egN4Qp

Best Screw Driver Set For Repairing - https://amzn.to/2OsA0ND

Best Cord less Screw Driver Set - https://amzn.to/3eqvtWw

Best & Cheap Digital Multimeter - https://amzn.to/467dOOb

Best Fold Scope Microscope Basic Kit - https://amzn.to/393WI6o

Best & Smallest 60x Microscope - https://amzn.to/477r5HQ

Microware-20x-to-1000x-8 Led-usb -   https://amzn.to/2W8DGs0

Best Magnifying-Soldering-Stand - https://amzn.to/2ZVcZrM

Supper LED TV Backlight tester - https://amzn.to/3gLyXEo

Mini Hand Drill and 20pcs Drill Bits - https://amzn.to/3fiEWAc

Popular Posts