Where all colors are involved - the lines are essentially white or gray (or
with a slight tint due to slight unequal settings of the color adjustments),
look for something common like an incorrectly adjusted screen (G2) or master
brightness/background/bias control or a problem in one of these circuits, a
defective power supply or a problem in the blanking circuitry:
- Screen (G2) or master brightness/background/bias control - mark setting and then see if a slight adjustment removes the retrace lines. See the chapter: "TV Adjustments". Of course, if this happened suddenly, the problem is not due to a misadjusted control though a dirty pot is possible - turn it back and forth - this might clean it and restore normal operation.
- Power supply or connection to CRT neck board - insufficient voltage will result in the CRT never totally blanking. Check (usually scan derived) power supply components (from flyback).
- General power supply - check B+ for correct value and ripple. A main power supply fault might result in these symptoms (and usually many others).
- Blanking circuit - this may be a part of the video/chroma chip or separate. Check waveforms to determine if the blanking pulses are making it to the video output.
No comments:
Post a Comment